Redis常用配置解析

浅浅的花香味﹌ 2021-11-09 05:38 504阅读 0赞

## 主机访问权限 ##

如果不设置限制，直接把这一行注释掉即可；

# By default, if no "bind" configuration directive is specified, Redis listens
    # for connections from all the network interfaces available on the server.
    # It is possible to listen to just one or multiple selected interfaces using
    # the "bind" configuration directive, followed by one or more IP addresses.
    #
    # Examples:
    #
    # bind 192.168.1.100 10.0.0.1
    # bind 127.0.0.1 ::1
    #
    # ~~~ WARNING ~~~ If the computer running Redis is directly exposed to the
    # internet, binding to all the interfaces is dangerous and will expose the
    # instance to everybody on the internet. So by default we uncomment the
    # following bind directive, that will force Redis to listen only into
    # the IPv4 loopback interface address (this means Redis will be able to
    # accept connections only from clients running into the same computer it
    # is running).
    #
    # IF YOU ARE SURE YOU WANT YOUR INSTANCE TO LISTEN TO ALL THE INTERFACES
    # JUST COMMENT THE FOLLOWING LINE.
    # ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
    bind 127.0.0.1

## 默认端口 ##

默认的监听端口，安全起见，通常换一个别的；

# Accept connections on the specified port, default is 6379 (IANA #815344).
    # If port 0 is specified Redis will not listen on a TCP socket.
    port 6379

## 守护模式 ##

两个值可选：`yes`、`no`；

# By default Redis does not run as a daemon. Use 'yes' if you need it.
    # Note that Redis will write a pid file in /var/run/redis.pid when daemonized.
    daemonize yes

## 保护模式 ##

两个值可选：`yes`、`no`；

# Protected mode is a layer of security protection, in order to avoid that
    # Redis instances left open on the internet are accessed and exploited.
    #
    # When protected mode is on and if:
    #
    # 1) The server is not binding explicitly to a set of addresses using the
    # "bind" directive.
    # 2) No password is configured.
    #
    # The server only accepts connections from clients connecting from the
    # IPv4 and IPv6 loopback addresses 127.0.0.1 and ::1, and from Unix domain
    # sockets.
    #
    # By default protected mode is enabled. You should disable it only if
    # you are sure you want clients from other hosts to connect to Redis
    # even if no authentication is configured, nor a specific set of interfaces
    # are explicitly listed using the "bind" directive.
    protected-mode yes

## 设置密码 ##

直接设置密码即可；

# Require clients to issue AUTH <PASSWORD> before processing any other
    # commands. This might be useful in environments in which you do not trust
    # others with access to the host running redis-server.
    #
    # This should stay commented out for backward compatibility and because most
    # people do not need auth (e.g. they run their own servers).
    #
    # Warning: since Redis is pretty fast an outside user can try up to
    # 150k passwords per second against a good box. This means that you should
    # use a very strong password otherwise it will be very easy to break.
    #
    requirepass your-password